RP1200 (Grinder) & RP1200M (Milling Only) CYLINDER HEAD AND BLOCK SURFACE GRINDER & MILLING MACHINES
FEATURES:
Resurfaces Head and Blocks up to 46" Long and 23 1/2" Height.
Easily Handles 6-71 Detroit Head and Block.
Power Up and Down Column.
Infinitely Variable Hydraulic Table Traverse.
CBN High Speed Milling Standard on RP1200M; Available (13 7/8" Dia.) on RP1200
Fingertip Line-Up Fixture.
RTM225 SERIES CRANKSHAFT GRINDER
Features a Heavy Duty Head and Tailstock, 4-way Cross-Slide Swing Heads, Quick Lock 360o Heads with Finger Tip Adjustment. Air Float Head & Tailstock.
RTM225A is ideal for basic crank grinding and can be equipped with a Hydraulic Wheel Dresser.
ACP160A FEATURES
All the Same Features as the ACP160M
Automatic Tool Indexing
Automatic Spindle Retraction
Boring Range 2 7/8" to 6 3/32"
Programmable CNC Parameters
HC-1DP, HC-2DP (Diamond) HC-3DP & HC 1/D
FEATURES:
Use diamond abrasives (HC-1DP, HC-2DP only)
Fast, convenient block rollover fixture.
Improve honing speed with use of the friction-feed hone.
Allow honing with main caps on or off.
Provide greater operator safety.
Eliminate the hazards and drugery of hand honing.
Provide wet honing capability, 15 gallon oil standard.
Make possible greater accuracy and better finish.
The Load Meter tells the operator at a glance where the cylinder is tight.
The Hone Head rolls laterally on ball bearings for fast, fingertip lateral positioning.
Furnished with a 1 3/4" square bar to hold down blocks to be honed with main caps on.
Both a momentary "Jog" Button, and a maintained Switch are standard on HC-1 & HC-D only. The "Jog" Button is very valuable for faster and safer set-up.
D30S
FEATURES:
Insulated cabinets are energy efficient and quiet.
Positive door seal eliminates offensive fumes.
Separate rinse plumbing does not dilute chemicals.
Large capacity filter also holds small parts for soaking.
Positive gearbox/motor turntable drive system.
Precision fan nozzles produce high presure/volume spray that shears off caked grease and grime.
UL approve electrical panels are standard.
Door safety switch stops pump if door is opened.
Vertical shaft, enclosed pump with no seals.
Cleaning fluid temperature is thermostat and 7-day timer controlled for optimum cleaning.
Diverter and safety switch prevent loss of chemical.
